COOL POWER MULT-VISCOSITY SYNTHETIC OIL PURLE 1LT - COOL POWER

BY â BRIAN WINCH. Review of modelling products conducted by the AIRBORNE ENGIN-EAR. COOLPOWER MULTI-VISCOSITY OIL â (Purple) PURPLE â THE ROYAL COLOUR. What is purple and goes âglurk, glurk, glurkâ? Stand up the boy who said âa purple chook when you are holding it by the neckâ! The correct answer is the new Coolpower Multi Viscosity PURPLE oil. Even if youâre not into engineering and lubrication in a big way you would understand that oil has a drag factor. Going to extremes, an oil as thick as honey is going to be harder to spread around than the oil you put on the skin of a baby. The effect is call âlubricity dragâ â a fluid friction that increases as the viscosity of the oil goes up the scale. Shock, horror again here for the âcastor brigadeâ but the fact it that castor is high on the scale. There is a usage level with the type of oil and its viscosity whereby, if exceeded, the drag actually robs power from your engine. Consider the oil used for full size car engines. Years back an engine in good condition would use 30 weight oil in winter and 50 weight in summer. Some of the high performance chasers used 20 weight oil but, in those days, it was way behind the technology of today and, quite often, the engine suffered badly. In our model engines with the oil as part of the fuel mix, fluid friction with the moderate to heavy oils comes in above around 16% lubrication. Now some eyelid fluttering smartass is going to give me a jab by bringing up pylon engines. In pylon racing the fuel is 20 castor â 80 methanol â the standard for all competitions. Well, the fact it that all the engines are on a level peg as they all use the same fuel. No one engine would gain from a different fuel mix as different fuels are not allowed. There is every chance in the world that the engine speed would increase a little if a lighter weight oil was used or, say, only 15% castor. The model car blokes run as low as 8% oil at times and those engines really hoot. A good quality car engine out of the box is looking a 30 â 35,000 rpm. Yes, yes, I know, different load factors and all that but they still go bloody hard and synthetic oil is the most popular lubricant. Back to the drag bit and what it means to you. Well, if you didnât know about it before then it hasnât worried you and it will not be a concern to the majority of modellers. In any case, if you are using a proprietary brand ready mixed fuel there is a good chance that the oil content could be as low as 14% if it is not stated on the container. This new oil does not replace the very popular Coolpower Blue or the Heli Red, it comes sort of in the middle and is aimed at special applications although it can be used for all fuels including methanol, petrol, diesel fuel and it will mix at any ratio with nitro methane and also blend with quite a few other lubricants. Brand: COOL POWER